ACM

The company manufactures its line of cartridge assembly seals for industrial pumps, agitators, reactors, and Industrial Compressor Seals. They also specialize in mechanical seals emergency repair services 24/7 to minimize industrial downtime.

Oil seals, which are also referred to as radial shaft seals, rotary shaft seals, grease seals, or fluid seals, are used to close the gaps between fixed and moving parts of mechanical equipment. They are put between moving and stationary mechanical parts to make sure that moisture, contaminants, corrosive materials, and abrasives don’t cause any damage to these parts.

＜Seal selection example＞
Based on the above flowcharts, the oil seal type that meets the requirements shown in Table 3 would be the type code MHSA or HMSA shown in Table 4.

 Oil seals go by many names, such as shaft seals, dirt seals, grease seals, lip seals, and many other variations of these. They are essentially simple devices used in rotary shaft equipment to prevent lubricant from escaping and for excluding contaminants such as dust, dirt and water. An oil seal’s most important function, however, is that it protects every type of ball, sleeve and roller bearing in the rotating shafts. The seals also prevent the integration of two different fluids that shouldn’t mix, such as oil and water.

The shaft on which the oil seal is mounted has to be ground to a rough surface finish. The shaft also should be hardened to prevent grooves forming on the shaft when the pressure is exerted by the spring on the seal. The area where the seal is fitted also has to be ground to prevent grooves that tend to wear out the lip of the oil seal faster than normal.