- Fruit green and grass green plastic-coated barbed rope can be said to be the special purpose of the highway, the rest of the use is relatively small.
- 1, we should pay attention to the welding mesh moisture-proof: if it is just the general outdoor air humidity, do not bother. If the weather is foggy, use dry cotton cloth to wipe the bead on the welding mesh; If it rains, you should dry the water when the rain stops. Try to maintain and prolong the life of the welding mesh.
3, galvanized silk mesh binder transport, storage and use should be in accordance with the relevant provisions to adopt safety, fire prevention methods, so as to be more safe use.
- The management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate. The concentration of plating aid should not be too high. Hot plating wire must be added ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled in the range of 50~80g/L. The addition of ammonium chloride or zinc chloride raw materials without the results of laboratory analysis shall be subject to criticism and education, and economic treatment if necessary.
Some customers pay more attention to the quality problem, so they pay more attention to the service life. The barbed rope factory will generally recommend the use of high zinc barbed rope or stainless steel barbed rope.
- Because the anti-aging and anti-corrosion ability of zinc and aluminum alloy wire is much higher than galvanized barbed rope, it is widely used in a variety of places with few personnel and lack of maintenance ability, and there is the protection of coastal areas.
Some customers pay more attention to the quality problem, so they pay more attention to the service life. The barbed rope factory will generally recommend the use of high zinc barbed rope or stainless steel barbed rope.
Unless the stainless steel blade barbed rope is specially customized, it is usually produced by the mould with the knife length of 22mm, which is the BTO-22 type we usually call. This is not necessarily the specification from 11mm to 65mm are specifications. Unless the customer insists on customized length requirements, the barbed rope manufacturer will produce BTO-22 stainless steel blade barbed rope.
- One is to do a good job of galvanized wire packaging, avoid bumping, to ensure the integrity of the zinc layer;
Different from common zinc barbed rope, high zinc barbed rope surface zinc content is very high can reach 6-8 times of the former, so there is a great advantage in the service life, ordinary products begin to corrosion three to five years while the latter will take longer to change. Stainless steel barbed rope is in material protection so durability is also better, these two products are long service life, but in terms of high price.
- Now a lot of hardware manufacturers are producing iron wire, and the iron wire is very easy to rust, if you need to use in outdoor or humid places, the general customer will require the use of galvanized iron wire equipment to give the wire a layer of zinc, the thickness can be determined according to user requirements. Galvanized iron wire equipment is specially used for iron plating. Generally speaking, the stability of zinc is much higher than that of iron, and it will not rust in the daily water vapor or wet place.
Generally, galvanized wire used for welding is required to have a certain hardness. After acceptance of galvanized wire, the first thing to do is to feel the hand, and the other thing is to test on the machine. Because the average user does not have testing equipment, it is also very inconvenient to test on the machine. Use a micrometer to measure the diameter of galvanized wire evenly, and keep it about 0.02mm above and below the contract signing standard, with neat appearance, no leakage plating and no mess.
“Dry” hot dip galvanizing is also called “drying solvent method” hot dip galvanizing. Iron and steel work pieces through degreasing, pickling, cleaning, dipping aid solvent and drying, and then immersed in the molten zinc solution to galvanize. The co-solvent is usually hydrochloric acid, ammonium chloride, or ammonium chloride mixed with zinc chloride in aqueous solution.
The large hexagonal mesh is called the stone cage net. Stone cage net before delivery, must be folded into a simple surface, packed compressed after delivery. Then put it in the right position to open, and then the block diameter suitable stone into the cage, the cover is tight, and then the various stone cage net and the adjacent stone cage net tied up.
Aquaculture galvanized electric welding net this mesh structure is convenient for construction, to ensure quality. Compared with the traditional manual binding, it can ensure the quality of the project, shorten the construction of drug control and shorten the construction period. So now such grids are also being used in new rural construction to enhance wall tension and to prevent earthquakes.
Galvanized hook mesh standard is thorough, mesh planning: 3cm-20cm, silk planning: 1.2mm-4.5mm, galvanized hook mesh 6000 square meters, some standards are available. Benefits: The selection of low carbon steel wire, surface for cold galvanized (electric galvanized) hot dip galvanized anticorrosion treatment, mesh wire strong, strong protection, long anticorrosion time.
- “Wet” hot dip galvanizing is also called “molten solvent method” hot dip galvanizing. Iron and steel workpiece through degreasing, pickling and cleaning, it is necessary to set in a special box above the surface of the molten zinc in the “molten solvent” (also called cosolvent), and then into the zinc liquid to galvanized. The molten solvent is usually a mixture of ammonium chloride and zinc chloride, but also other chlorine salts.
- The wire after the first plating, its strength limit is also higher than the first plating, plated zinc and then made of wire not only toughness and high strength. There is a lower figure in the strength limit of galvanized iron wire because of the quality of zinc, because the strength of zinc technology is several times smaller than the wire itself. It is difficult to hot-dip galvanize drawn wires, and it is impossible for finer and very fine wires to be coated with the desired thickness of smooth zinc.
Pet cages have many kinds, the selectivity is relatively large, pet cages are generally made of a little thick wire, and then at the bottom of the base with wheels, so a simple pet cage is made, at the bottom of the wheels is to facilitate the movement of a pet cage, but also should be made in suitable position in addition to a door, Convenience comes in handy when it comes to pet feeding.
The welding process of galvanized steel wire mesh because of low carbon steel carbon content is low, manganese and silicon content is low, will not occur severe hardening or quenching structure due to welding. The low carbon steel joints have excellent plasticity and impact toughness after welding. In the welding process, it is generally not necessary to preheat, interlayer temperature control, post-heating control and heat treatment to improve the welding structure.
In order to make the zinc content of steel wire stable in the future, and maintain its uniformity, as far as possible to reduce the zinc content, and effectively reduce zinc consumption to the actual work, the following measures are proposed by the wire factory:
Post time: 29-04-22With the improvement of people’s living standard, pet raising is becoming more and more common. Pets also need a comfortable environment, so pet cage is an ideal choice for pet raising. Dogs are loyal friends of human beings. They will accompany you all your life and protect you until you die. Raising small animals can bring comfort to lonely old people; Patients who receive visits from animals can improve their depressed moods and even relieve pain. Families with pets add joy and cohesion; Companion animals usually form familial bonds with their owners.
- Barbed wire mesh is iron mesh with high anti-corrosion function, the same is also one of the net class of iron mesh is widely used, its efficient anti-corrosion function in aquaculture, construction and other aspects are very popular. Its smooth and regular mesh surface not only increases its own beauty, but also can play a certain decoration effect.
The galvanized layer forms a particular metallurgical structure that is capable of accepting mechanical damage during transport and use. Every part of the plating can be zinc plated, even in dents, sharp corners and hidden places can be fully maintained. The galvanizing process is more convenient than other coating construction methods, and can avoid the required time after the installation on the site.