Before installing the oil seal, it is essential that the oil seal, shaft and bore are not damaged. So, ensure that the surfaces the oil seal comes in contact with do not have any sharp points or burrs. The sealing lip is fragile, so any minor damage to it can cause leakage. Also, make sure the oil seal is clean. Even a small amount of dirt can cause a leak. Therefore, never use a pre-used oil seal for the assembly.

Oil Seal Materials

Sealing process

Loosen all the sump nuts or bolts with a socket, long extension bar and ratchet handle.

Oil seal performance is affected by not only the type and material of the selected oil seal, but also a variety of other factors, such as operating conditions, total eccentricity, rotational speed, the substance to be sealed, and lubrication conditions.
Figure 9 shows items relating to oil seal characteristics.

4. Installing a new seal

Material Selection:

Requirements of the shaft
Even more important than a correct interference fit of the Oil Seal is a perfectly smooth shaft in the region of the seal, particularly if shaft surface speed is high and the medium to be sealed is under a certain amount of excess pressure. The surface roughness of the shaft depends on the average profile depth Ra of the tool marks caused by the machining process. Oil Seals made of PTFE require, independent of the surface speed, a surface roughness of between 0,1 to 0,2 mm, because PTFE has less wear resistance than rubber seals. For normal circumstances, the shaft in the region of the seal must have a surface roughness of approximately:  To summarize, the surface of the shaft in the region of the seal should not have noticeable machining marks. For pivoting shafts and other difficult or critical sealing applications, it is recommended that Oil Seals with a helical groove hydrodynamic pattern, which has a pumping effect, be used. When grinding and polishing, an axial movement of the grindstone along the shaft must be avoided in order to prevent machine lay.