The management system of the rinsing water after the steel wire pickling should be regularly and regularly discharged after the rinsing water, and the rinsing water should be kept clean and low acid value as far as possible. The pH control is more appropriate. The concentration of plating aid should not be too high. Hot plating wire must be added ammonium chloride and zinc chloride according to the data of laboratory analysis, and the specific gravity of the composite solution is controlled in the range of 50~80g/L. The addition of ammonium chloride or zinc chloride raw materials without the results of laboratory analysis shall be subject to criticism and education, and economic treatment if necessary.
Now it is more used in the binding of the construction industry. Compared with ordinary wire, it is also softer and has better luster. Use in daily life does not need to carry out maintenance and maintenance, saving a lot of time, but also save the cost of maintenance and maintenance. Annealed wire has good stability, good corrosion resistance, greatly prolonging the service life. There are many kinds, which can be selected according to different uses. The device for making annealed wire is simple, and the utilization rate of the device is improved. The material properties of annealed wire can meet different processing needs.
Post time: 11-10-22
Post time: 13-12-22
Post time: 26-04-23
Post time: 27-12-22- Galvanized wire coating is galvanized, aluminum plated, coated with nylon or plastic, etc. Zinc is divided into thin coating of steel wire after plating and thick coating of galvanized steel wire after drawing. The mechanical properties of thick coating are reduced compared with smooth steel wire rope, which should be used in severe corrosion environment. It is more resistant to corrosion, wear and heat than galvanized wire rope, using the first plating and then drawing method of production. Coated nylon or plastic wire rope is divided into two kinds of coated rope and coated stock after the rope.
Pet cage from the use of material can be divided into plastic, wire, wire square tube, stainless steel four. General small animal cage multi-purpose is plastic and wire material, such as a lot of hamster cage, chinchilla cage are made of plastic or wire, small aquarium is plastic products, and the vast majority of small and medium-sized bird cage are wire products. The characteristics of this kind of small animal cage, is small, light, easy to carry, but also easy to clean care. For small animal cages, the wire diameter of the general iron wire is not very large, the thickness of the plastic is relatively thin, so the use of the time can not be “violent”, or the cage under the “destruction” will occur welding or plastic crack off.
- 2. Quantity and packing
Post time: 12-01-23We contrast the difference between galvanized electric welding mesh and other electric welding mesh by introducing in detail, and the following describes its material: Galvanized welded wire mesh is made of low carbon wire, through automation of fine precision machinery equipment spot welding processing after forming, selection of disposal of the appearance of zinc leaching technology, produce practice British standard, with smooth surface neat, uniform layout to consolidate, the function is good, even if some sections or accept pressure also won’t attack lax appearances, it is the strongest anti-corrosion function in iron mesh, Screen mesh is iron use one of the most widely network class, excellent anticorrosive makes its popularity in the breeding, sucking the neat surface, increased the look and feel, can play will be decorating effect, this feature makes it reflected in the mining industry, because the select material of low carbon high quality material, make it unique iron mesh not usually have flexibility, Concluded that it in the use of plasticity in the process, and then can be used for hardware technology in the deep processing and production, disorderly wall batch swing, underground leakage prevention crack, light mesh body, so that the cost is much lower than the cost of iron screen, more able to understand its economic and practical. Galvanized electric welding net can be used as poultry cage, egg basket, channel fence, drain sink, porch fence, rat net, mechanical shield, livestock and plant fence, grid frame, etc. It is also widely used in industry, agriculture, construction, transport, mining and other occupations.
1. High tensile strength and durability
- Annealing is to restore the plasticity of wire, improve the tensile strength of wire, hardness, elastic limit, etc., the wire after annealing is called annealing wire. In the production process of annealing wire, it is very important to ensure the quality of the finished wire, make the wire have certain strength and suitable degree of soft and hard. The annealing temperature is between 800 ℃ and 850℃, and the length of furnace tube is lengthened appropriately for enough holding time.
When large rolls of galvanized wire are used to bind and reinforce the goods, corresponding binding methods should be selected according to the fastening node conditions of the strengthened goods, such as opening binding, opening binding, insertion binding and so on. The insulation layer of semi-hard and soft insulation products shall be based on the diameter of the steel pipe and the size of the equipment. Large rolls of galvanized wire or glue are tied together with a width of 60mm. The binding interval of semi-hard insulating products shall not exceed 300 mm; The larger length of felt and cushion shall not exceed 200mm, and the number of belts shall not be less than 2.
Hexagonal mesh is also known as twisted mesh, insulation mesh, soft edge mesh. It is made of a single mesh reel. The mesh, mesh, galvanized and PVC coated properties are the same as the cage. This product can be different shapes, sizes of the stone into the alloy net to form a flexible whole, can be lifted, cars, shipping to the L place, the alloy net connected into a larger whole, the construction of throwing convenient, fast, good economic performance.
- The wire mesh is finished by fine welding of active welding equipment. The material can be divided into cold drawing wire, hot dip galvanized, cold galvanized, dip plastic and so on. To be used for bridge reinforcement, deck paving, building reinforcement, etc.
- Generally speaking, it is necessary to install thorn rope in pasture, which is simpler and saves time and effort. It is better managed because it is full of spikes that keep livestock away from the barbed fence.
There are many important details that need to be paid special attention to during the production of barbed rope or blade barbed rope by the barbed rope factory. If any improper, it will cause unnecessary losses.
Railway is not only the main artery of national economy, but also an important means of mass transportation to protect people’s travel. It plays an important role in the process of economic and social development. Therefore, the safety issue is an important guarantee for railway transportation, one is a symbol of the railway transportation enterprise product quality, the other is also the focus of social attention. The off-road collision accident is one of the focus of public opinion on the railway industry. How to grasp the off-road safety management, eliminate the off-road collision accident from the source, maximize the protection of people’s life and property safety, and reduce the non-operational cost of railway enterprises is a key content of railway safety work in the new era. We should install protective nets on both sides of the railway, which are also barbed wire protective nets, so as to prevent accidents.
And the role of wire mesh in the exterior wall plastering if from an Angle to sail a method of anti-falling, the role of anti-cracking is relatively small, because of the problem of orientation; And about the external insulation system is used in the tile veneer, as for the role should also be anti-drop followed by anti-cracking, so the grid should be selected 10×10×0.6, these are some experience selection, grid conversion from the national provisions of the wire mesh standard, choose the level of steel conversion.
- First, cold galvanized wire production process before treatment. Before galvanizing, a series of pre-treatment work on the steel wire is required, mainly including pickling, dissolution and brine or alkali washing.
- In want to use barbed wire fence ground road at both ends of each set up a stake, and then from the two stakes, every 30m to set up a stake, until the installation of the line is full of stakes, so installed barbed wire net is a straight line.
- 1) wire thickness: we also know that the pet cage wire is too thin to be easily bitten off by dogs, the general cage wire on the market are 3mm steel wire, such wire is only suitable for small dogs or rabbits, for large dog friends I suggest to buy more than 4mm thick.
- Six: The characteristics of spray blade barbed rope are mechanical strength, adhesion, corrosion resistance, aging resistance, etc., which will greatly increase the service life of the barbed rope, anti-ultraviolet, anti-aging weathering.
Post time: 13-06-24
Post time: 22-07-22- Of course, the quality of any product is also affected by the implementation of the manufacturer’s norms. If it is the manufacturer of electric welding mesh in production, it does not have a high implementation of the norms, or the procedural norms on the production line have decreased, or there is no higher requirements on the production link.
- And the role of wire mesh in the exterior wall plastering if from an Angle to sail a method of anti-falling, the role of anti-cracking is relatively small, because of the problem of orientation; And about the external insulation system is used in the tile veneer, as for the role should also be anti falling followed by anti-cracking, so the grid should be selected 10×10×0.6, these are some experience selection, grid conversion from the national provisions of the wire mesh standard, choose the level of steel content conversion.
In general, the hardness of a metal is often considered to be the resistance of the material to plastic deformation, scratches, wear, or cutting. In the debugging of zinc wire dipping distance, keep the original speed unchanged, according to the time of dipping zinc, the diameter of steel wire, and then estimate the dipping distance. By adjusting the zinc immersion distance, the zinc immersion time of steel wire of various specifications is shortened by 5s on average compared with that before debugging, so that the zinc consumption per ton of steel wire is reduced from 61kg to 59.4kg.