The skin of an adult person is, in most places, covered with a relatively thick (∼10 μm) barrier of keratinised dead cells. One of the main questions is still whether TiO₂ NPs are able to penetrate into the deeper layers of the skin. The majority of studies suggest that TiO₂ NPs, neither uncoated nor coated (SiO₂, Al₂O₃ and SiO₂/Al₂O₃) of different crystalline structures, penetrate normal animal or human skin. However, in most of these studies the exposures were short term (up to 48 h); only few long-term or repeated exposure studies have been published. Wu et al.83 have shown that dermal application of nano-TiO₂ of different crystal structures and sizes (4–90 nm) to pig ears for 30 days did not result in penetration of NPs beyond deep epidermis. On the other hand, in the same study the authors reported dermal penetration of TiO₂ NPs with subsequent appearance of lesions in multiple organs in hairless mice, that were dermal exposed to nano-TiO₂ for 60 days. However, the relevance of this study for human exposure is not conclusive because hairless mice skin has abnormal hair follicles, and mice stratum corneum has higher lipid content than human stratum corneum, which may contribute to different penetration. Recently Sadrieh et al. performed a 4 week dermal exposure to three different TiO₂ particles (uncoated submicron-sized, uncoated nano-sized and coated nano-sized) in 5 % sunscreen formulation with minipigs. They found elevated titanium levels in epidermis, dermis and in inguinal lymph nodes, but not in precapsular and submandibular lymph nodes and in liver. With the energy dispersive X-ray spectrometry and transmission electron microscopy (TEM) analysis the authors confirmed presence of few TiO₂ particles in dermis and calculated that uncoated nano-sized TiO₂ particles observed in dermis represented only 0.00008 % of the total applied amount of TiO₂ particles. Based on the same assumptions used by the authors in their calculations it can be calculated that the total number of particles applied was 1.8 × 10¹³ /cm² and of these 1.4 x10⁷/cm² penetrated. The surface area of skin in humans is around 1.8 m²  and for sun protection the cream is applied over whole body, which would mean that 4 week usage of such cream with 5 % TiO₂ would result in penetration of totally 2.6 × 10¹⁰ particles. Although Sadrieh et al.concluded that there was no significant penetration of TiO₂ NPs through intact normal epidermis, the results are not completely confirmative.

Demand in the European region has been significantly boosted by higher offtakes in the furniture, building, and industrial sectors compared to Q2, after a boost in containment measures. DIY activities increased significantly as people engaged in more home renovation and building tasks during the extended period of lockdown. With the restart of Chinese shipments in the latter half of Q2 2020, supply has also remained plentiful.

Titanium dioxide in food

As an professional Lithopone factory, Jinan Hongquan Titanium Industry Co., Ltd is located in Jinan, a beautiful spring city. The company’s scientific research personnel sincerely cooperate with well-known domestic universities and various titanium dioxide production enterprises to study and produce active Lithopone with great concentration. Some of its products have been widely used in chemical, textile, paper, plastic, paint and other production fields.

In a 2016 study published in Scientifica (Cairo), Egyptian researchers examined the effects of titanium dioxide nanoparticles on the organs of mice by orally administering the food additive daily, for five days. The results showed that the exposure produced “mild to moderate changes in the cytoarchitecture of brain tissue in a time dependent manner.” Furthermore, “Comet assay revealed the apoptotic DNA fragmentation, while PCR-SSCP pattern and direct sequencing showed point mutation of Presenilin 1 gene at exon 5, gene linked to inherited forms of Alzheimer’s disease.” The researchers wrote: “From these findings, “the present study concluded that TiO2NPs is genotoxic and mutagenic to brain tissue which in turn might lead to Alzheimer’s disease incidence.”

After oral ingestion, the absorption of titanium dioxide particles is low, however they can accumulate in the body, Maged Younes, chair of the European Food Safety Authority's expert Panel on Food Additives and Flavourings, said in a May 2021 statement.

Prof. Matthew Wright, chair of EFSA’s working group on E171, noted: “Although the evidence for general toxic effects was not conclusive, on the basis of the new data and strengthened methods we could not rule out a concern for genotoxicity and consequently we could not establish a safe level for daily intake of the food additive.”

How we’re exposed to an ingredient matters greatly in terms of our long-term health. 
  
Research shows that inhaling titanium dioxide particles in significant quantities over time can cause adverse health outcomes. Unless you work in an industrial setting, inhaling substantial amounts of titanium dioxide is highly unlikely. 

For research published in 2022 study in the journal Food and Chemical Toxicology, scientists examined “the genotoxicity and the intracellular reactive oxygen species induction by physiologically relevant concentrations of three different TiO2 nanomaterials in Caco-2 and HT29-MTX-E12 intestinal cells, while considering the potential influence of the digestion process in the NMs’ physiochemical characteristics.” They found a “DNA-damaging effect dependent on the nanomaterial,” along with the micronucleus assay suggesting “effects on chromosomal integrity, an indicator of cancer risk, in the HT29-MTX-E12 cells, for all the tested TiO2 nanomaterials.” Researchers concluded that the results showcase “evidence of concern” regarding titanium dioxide used as a food additive.

A dense, white, opaque pigment composed of a mixture of Zinc sulfide (30%) and Barium sulfate (70%) with trace amounts of Zinc oxide. Lithopone, first produced in 1874, was called Orr's white. The mixture of the two components is so intimate that it is hard to distinguish microscopically. Lithopone is an inert, transparent pigment which is often used as a filler or as a base for lake pigments. Lithopone was widely used in house paints in the first half of the 20th century. It was also used for some artist grounds, inks and as a filler in Paper, Leather, and Linoleum. Now lithopone has mostly been replaced by Titanium dioxide.

Titanium dioxide can amplify and brighten white opacity because of its exceptional light-scattering properties. In food and drugs, these properties help to define colors clearly and can prevent products from UV degradation. 

Lithopone or sulphide of zinc white has been in general use for twenty years or more in many industries where a white pigment of considerable body or hiding power is required that is not subject to change like lead carbonate and has not the brittle character of zinc oxide, besides being sold at a lower figure than either of these. Nevertheless it is still comparatively new to the general painting trade. Because of our tariff protection its manufacture in this country has made great progress. Yet in spite of this and the duty imposed on it, the imports are still in excess of the quantity manufactured here. A short history of its origin will no doubt prove of interest to our readers.

TiO₂ is typically thought of as being chemically inert, meaning it does not react with other chemicals and is, therefore, a stable substance that can be used in many different industries and for various applications.

Although barium sulfate is almost completely inert, zinc sulfide degrades upon exposure to UV light, leading to darkening of the pigment. The severity of this UV reaction is dependent on a combination of two factors; how much zinc sulfide makes up the pigments formulation, and its total accumulated UV exposure. Depending on these factors the pigment itself can vary in shade over time, ranging from pure white all the way to grey or even black. To suppress this effect, a dopant may be used, such as a small amount of cobalt salts, which would be added to the formulation. This process creates cobalt-doped zinc sulfide. The cobalt salts help to stabilize zinc sulfide so it will not have as severe a reaction to UV exposure.