Apart from proximately neuromorphic technologies, TiO₂-based memristors have also found application in various sensors. The principle of memristive sensorics is based on the dependency of the resistive switching on various external stimuli. This includes recording of mechanical energy (Vilmi et al., 2016), hydrogen detection (Hossein-Babaei and Rahbarpour, 2011; Strungaru et al., 2015; Haidry et al., 2017; Vidiš et al., 2019), γ-ray sensing (Abunahla et al., 2016), and various fluidic-based sensors, such as sensors for pH (Hadis et al., 2015a) and glucose concentration (Hadis et al., 2015b). In addition, TiO₂ thin films may generate photoinduced electron–hole pairs, which give rise to UV radiation sensors (Hossein-Babaei et al., 2012). Recently, the biosensing properties of TiO₂-based memristors have been demonstrated in the detection of the bovine serum albumin protein molecule (Sahu and Jammalamadaka, 2019). Furthermore, this work has also demonstrated that the introduction of an additional graphene oxide layer may effectively prevent the growth of multidimensional and random conductive paths, resulting in a lower switching voltage, better endurance, and a higher resistance switching ratio. This opens up a new horizon for further functional convergence of metal oxides and two-dimensional memristive materials and interfaces (Zhang et al., 2019a).

Polyvinyl Butyral Resin (PVB) is a solvent Resin synthesized by the acetal reaction of Polyvinyl Alcohol (PVA) and butyraldehyde in contact with coal.

Because Pvb Resin itself contains a lot of hydroxyl groups, it can bridge with some thermosetting resins to improve the properties of chemicals and film hardness.

Because PVB resin has the above excellent characteristics, it is widely used in adhesive safety glass intermediate film of automobile and building, rust cutting primer, baking paint, wood paint, printing ink, adhesive of electronic ceramics and printed circuit board, adhesive between metal and metal, between metal and plastic, modifier of hot-melt adhesive, iron dimension waterproof processing of textile, etc. A variety of new industrial applications are also continuously developed and applied.

The general characteristics of PVB are as follows:

The appearance of polyvinyl butyral (PVB) resin is white spherical porous particles or powder, and its specific gravity is 1:1; However, the filling density is only 0.20 ~ 0.35g/ml.

Thermal properties

The glass transfer temperature (TG) of polyvinyl butyral (PVB) resin ranges from 50 ℃ of low degree of recombination to 90 ℃ of high degree of recombination; The glass transfer temperature can also be adjusted by adding an appropriate amount of Plasticizer to reduce it below 10 ℃.

Mechanical properties

The coating of polyvinyl butyral (PVB) resin has good water resistance, water resistance and oil resistance (it is resistant to aliphatic, mineral, animal and vegetable oils, but not to sesame oil). PVB is widely used in printing inks and coatings because it contains high hydroxyl groups and has good dispersibility to pigments.

In addition, its chemical structure contains both hydrophobic acetal and acetic ACID groups and hydrophilic hydroxyl groups, so PVB has good adhesion to glass, metal, plastic, leather and wood.

Chemical reaction

Any chemical that can react with secondary alcohol will also react with PVB. Therefore, in many applications of PVB, it is often used with thermosetting resin to bridge and harden with the hydroxyl group of PVB, so as to achieve the characteristics of chemical resistance, solvent resistance and water resistance.

Of course, films with different characteristics (such as hardness, toughness, impact resistance, etc.) can be prepared according to different types of thermosetting resin and different mixing ratio with PVB.

Safety properties