- Similar to two materials in the coating part melting together, and coating thickness can reach 100 microns, so high corrosion resistance, salt spray test 96h no problem, equivalent to 10 years under the usual environment; Cold galvanizing is electroplating at room temperature. Although the thickness of the coating can also be controlled, the binding strength and thickness of the coating are relatively low, so the corrosion resistance is poor.
Post time: 19-09-22
Post time: 15-11-22In order to pack and bind galvanized wire in the surface of the sedimentary layer to local removal of surface film, surface inclusion and other defects can be found and treated by conventional technology; Excess foam is formed when soap and surfactants such as saponified fats are brought into the tank. Moderate rates of foam formation may be harmless. Small, homogeneous particles of large denier present in the bath can stabilize the foam layer. Use activated carbon mat to remove surface active substance. Or through filtration to make the foam is not too stable, which are effective measures; Other measures should also be taken to reduce the amount of surfactant introduced. The electroplating speed can be obviously reduced by the addition of organic matter. Although chemical formulations facilitate high deposition rates, the deposition of organic matter does not meet the requirements of coating thickness, so activated carbon can be used to treat the bath.
During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.
Post time: 31-05-22- The most obvious gap in a short period of time is the cross section of this piece, hot dip galvanized wire because it is surface anti-corrosion treatment, so in the cross section of this piece will appear rust, and stainless steel wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.
Razor wire, also known as razor wire and razor net, is a new type of protective net. Blade barbed wire has beautiful, economic and practical, good anti-resistance effect, convenient construction and other excellent characteristics, at present, blade barbed wire has been widely used in many countries of industrial and mining enterprises, garden apartments, border posts, military fields, prisons, detention houses, government buildings and other countries of the security facilities.
Hot-dip galvanized wire has longer service life and better corrosion resistance than ordinary steel wire. Hot dip galvanizing is a method of chemical combination of zinc metal and steel wire surface, through the formation of a strong and self-healing zinc-iron alloy protective layer on the steel wire surface, so as to prevent direct contact between the steel wire and the external environment, reduce the possibility of oxidation corrosion, and extend the service life of the steel wire.
- Packaging: electric welding net general packaging for moisture-proof paper (color is mostly gray white, yellow, plus trademarks, certificates, etc.), some like 0.3-0.6mm domestic sales of small wire diameter electric welding net, because the wire is relatively soft, coupled with small volume, customers often require packing processing, in order to prevent shipment caused by damage. The wire of electric welding mesh has straight, also has a wavy bend (also known as the Dutch net)
The price of galvanized iron wire is relatively low, but the corrosion resistance is excellent, so it is favored by many screen businesses. In the production process of galvanized iron wire, first of all, we should check the equipment to see if there are any problems, and then we should look at the galvanized process, whether there are factors that cause product discoloration. If these problems do not exist, or some of them occur on the same equipment, and some are normal, then we should consider the problem of raw materials at this time.
- 1. Water washing: Clean the galvanized steel wire to remove the residual zinc liquid and impurities on the surface.
- The production and processing process of the blade thorn rope is complicated, which requires the cooperation of all departments, and the production cycle is relatively long. Whether galvanized rope or stainless steel rope, because of the relatively simple structure, the degree of mechanization in the production process is relatively high, so it is also a relatively big difference in price.
- Tolerance range: radial mesh deviation range is not more than ± 4%, zonal mesh deviation range is not more than ± 3%; Solder joint tensile strength exceeds the national standard.
Post time: 30-03-23
Post time: 09-10-22Welding mesh is also known as external wall insulation wire mesh, galvanized wire mesh, galvanized welding mesh, wire mesh, row welding mesh, touch welding mesh, construction mesh, external wall insulation mesh, decorative mesh, barbed wire, square eye mesh, screen mesh, anti-crack mesh. Stainless steel welding net, is made of high quality stainless steel wire row welding, more acid resistance, alkali resistance, solid welding, beautiful, wide use and so on.
Therefore, the rust of galvanized black iron wire has a great relationship with storage. At the same time, after rust, it should also be reasonable for post-treatment to avoid affecting its use effect. Of course, when the black iron wire is galvanized, the thickness of the galvanized layer should be ensured, so that the possibility of rust can be reduced. Speaking of galvanized iron wire, perhaps many people think it is relatively rare, in fact, it is not.
Hot dip galvanizing is a kind of external treatment technology in the production of fasteners. The common varieties of hot dip galvanizing fasteners are electric galvanizing, powder galvanizing, mechanical galvanizing and hot dip galvanizing. Wire factory according to different requirements of customers for fasteners, different hot-dip galvanized surface treatment. Galvanized layer and steel is a metallurgical connection, become a part of the steel surface, so the durability of the coating is more reliable.
- Large hexagonal net called stone cage net, mainly used for mountain preparedness protection, hydraulic construction, etc. Small wire hexagonal net is used as a good material for culture, will twist the hexagonal net in the welding of the iron frame on the hexagonal net welding into chicken cage, pigeon cage, rabbit cage and other cage, hexagonal net is an excellent material for culture with net.
- The cage can be placed in a corner so that the bird can see what is going on around it and can retreat to the back of the cage without fear of being approached. The height of the cage from the ground is also important and is ideal slightly below eye level.
- It is generally believed that the positive and negative twisting wire wire is not as durable as the thickness, common sense thinks so, but the positive and negative twisting wire wire is used in hot galvanized steel wire, which is more than 3 times the tensile strength of the iron wire, and the zinc amount is not lower than the hot plated wire
Post time: 17-08-22
Post time: 04-01-23The application of electric welding mesh is more widely, at present, it has replaced the use of other parts of the screen, the cost of electric welding mesh is low, the production speed is very fast, so it is very popular. The treatment required before galvanized welding mesh is recrystallization annealing, because the welding mesh must maintain an oxide and no other impurities of pure iron active surface, if you can’t keep its surface clean will lead to poor galvanized effect, galvanized layer and iron material is not tightly combined, so this step is necessary.
As we all know, iron wire rust is due to contact with water and oxygen chemical reaction, therefore, how to prevent galvanized iron wire rust, first of all, in the storage of galvanized iron wire should choose ventilated dry place, avoid wet or rain leakage, in use, in addition to follow the principle of first in first out, if accidentally caused by the destruction of galvanized layer, should be coated with anti-rust paint treatment, Otherwise, it is easy to lose the protection of galvanized layer and cause galvanized iron wire rust.
- Six: spray blade barbed rope features mechanical strength, adhesion, corrosion resistance, aging resistance, etc., will greatly increase the service life of the barbed rope, anti-UV, anti-aging weathering.