- The advantages of hook net hook net raw material resolution of its use, used for road guardrail, sports stadium fence, etc., because the weaving characteristics of hook net can make the guardrail both beautiful and useful, have a good ability to hit, and can extend the service life, not easy to fade to prevent the effect of beautiful. And can also be used for family interior decoration, because its plasticity is very good so the use is also very much, is now many local are widely used.
- Heavy hexagonal mesh is made of low carbon steel wire galvanized large wire braided, the tensile strength of steel wire is not less than 38kg/m2, the diameter of steel wire can reach 2.0mm-3.2mm, the surface of steel wire is usually hot galvanized protection, galvanized amount can reach 500g/m2.
- 3, the barbed rope protective net in the bridge, channel, should be in the direction of the bridge cone slope (or end wall), should not leave people, animals can drill into the gap.
Post time: 19-10-221, galvanized wire mesh molding sheet must be packed with flat hard data, to avoid eternal deformation due to poor packaging.
A pet carrier can be used as an indoor or outdoor pet house. The dog cage is equipped with a fixed food basin and water fountain, and the foot plate pet cage rubber pad has bayonets on four sides to be splintered. It can be spliced, cut and disassembled according to the size of the cage. It is convenient and easy to clean. It can solve the problem of pinching the feet of the puppies in the ordinary cage and prevent the puppies from causing adverse reactions in the development. The dividers are breathable and comfortable, and can be used as heat shields for pets in summer. A puppy with small feet, no feet, no pinching.
- In fact, although galvanized hook net is a useful material for iron products, but fundamentally speaking, modern hook net through continuous transformation and improvement, even if it seems to be not useful products, also have a role in its use, here we can turn our attention to people abandoned galvanized hook net.
Post time: 27-02-23- Attention should be paid to line collection and operation. Others shall not get on the train without the monitor’s consent. The wire reel should be put lightly, stacked firmly and neatly, not more than 5 discs. It is forbidden to contact human skin directly with acid and base. When the acid fog exceeds the specified target of the state, timely measures should be taken to control it; otherwise, production is not allowed.
- Two is to pay attention to the storage and use of galvanized wire products, according to the actual environmental standards to choose different specifications of galvanized wire products;
Post time: 29-07-22
Post time: 12-05-23
Post time: 02-03-23
Post time: 13-07-22Decorative hook mesh selection of stainless steel, aluminum alloy, brass, copper and other alloy materials, through the special process of preparation of hook mesh. It is a silk screen made of decoration. Today we introduce the aperture and wire diameter of the decorative hook mesh.
- 3, reduce the bivalent iron ion in the plating aid used for hot plating wire, reduce the formation of zinc slag
- Generally speaking, in dry main gas and indoor use, the thickness of galvanized coating is only 6-12μm, but under poor environmental conditions, the thickness of galvanized coating is 20μm, can reach 50μm. Therefore, environmental factors should be considered when choosing the thickness of galvanized layer. Galvanized layer after passivation treatment, can naturally form a layer of bright, beautiful color passivation film, can obviously improve its protective function, decorative.
There is no need to carry out daily maintenance and maintenance when in use, which can not only save a lot of time, but also reduce the cost, but also has good stability, strong corrosion resistance, greatly extend the service life. According to the different technology is divided into different types, can be selected according to their own needs, has better flexibility and elasticity. The main function of annealing wire is to control its hardness, when the annealing wire is made of steel wire.
- The application of electric welding network is more and more widely, and the technology is gradually mature, electroplating rust prevention, plastic processing, used for breeding, grille, coupled with the framework made of guardrail network.
- Zinc dipping time should be adjusted according to the thickness of wire diameter. The method of adjustment is to use the lead screw above the zinc pot, the length of the distance to the ceramic sinking roller. Thick wire diameter zinc dipping time should be long, fine wire diameter zinc dipping time should be short, zinc dipping length is in the range of 2~3.5m, which is also to reduce the zinc consumption of steel wire, is an aspect of maintaining the uniformity of zinc layer.
If not packaged, then a car of blade thorn rope can not be loaded with many pieces, but also relatively occupied places and easy to be lost in the process of transportation. Each bundle of blade barbed rope is 50 bundles. After hydraulic compression, the volume is reduced and it is more convenient to load and unload. Forklift trucks can load and unload easily. In general, when exporting, the blade thorn rope will be packaged for sale, so that the volume occupied in the container is relatively small, which can be very easy to size and place will not take up much place.
- Steel mesh benefits: Compared with traditional handmade steel mesh, steel mesh has better elasticity and even spacing. When pouring concrete, the steel mesh is not easy to bend, and the thickness of concrete protective layer is easy to control and even. In bridge deck surfacing, measure the protective layer of steel mesh. The pass rate is 95 percent.
Post time: 17-02-23The derusting steel parts are immersed in the melted zinc liquid at about 500℃, so that the surface of the steel member is attached with zinc layer, so as to achieve the purpose of anti-corrosion. The surface of galvanized wire coating can see whether the quality of galvanized wire is good or not. If the strength of zinc attached to the wire is very poor, then this galvanized wire do not buy, because this galvanized wire must be poor galvanized wire.
- Heavy hexagonal mesh is made of low carbon steel wire galvanized large wire braided, the tensile strength of steel wire is not less than 38kg/m2, the diameter of steel wire can reach 2.0mm-3.2mm, the surface of steel wire is usually hot galvanized protection, galvanized amount can reach 500g/m2.
Hook flower net is made of silk hook, the mesh is uniform, flat net surface, beautiful generous net width, wire diameter is thick, not easy to corrode long life, weaving succinct, beautiful and useful. Widely used for raising chickens, ducks, geese, rabbits and zoo enclosures. Mechanical equipment protection, highway guardrail, sports venues fence, road beautification belt protection network. After the screen is made into a box-like container, it can be used to maintain and support the seawall, hillside, road and bridge, reservoir and other civil engineering.
Post time: 19-05-231. Choose according to your dog’s size
- Two, galvanized to prolong the service life of stainless steel barbed rope
Hot dip galvanizing is then oiled and chromed. The quality of hot-galvanized sheet produced by this method is significantly improved compared with that by wet galvanizing method. It is only valuable for small-scale production. Continuous galvanizing production line includes a series of pretreatment procedures, such as alkali degreasing, hydrochloric acid pickling, water washing, solvent coating, drying, etc., and the original plate needs to be annealed in cover furnace before entering the galvanizing line.
Blade thorn rope because the volume is relatively large, so the thorn rope factory is used to packaging treatment.
Post time: 06-07-22The construction of inner wall and outer wall steel wire mesh can effectively solve the wall cracks, falling off, empty drum phenomenon. Hot dip galvanized steel wire mesh material requirements: net surface leveling, width and length to meet the project required standards, welding process, weight, zinc, etc., with more production and operation, detection certificate is complete.
During this process, each time the wire is pulled over, the surface hardens due to the high friction temperature. So basically every time you pull it you have to annealing it in the furnace. On the one hand, it is to reduce the surface hardness. On the other hand, during the process of wire pulling, only the surface is deformed, and the center is unchanged. So there’s a lot of stress inside. Therefore, it is necessary to rely on annealing to eliminate the internal stress, so that the wire becomes soft again to eliminate the stress before being drawn again.