Post time: 16-09-22- Hook mesh from the point of view of weaving quality inspection requirements, hook mesh wire and silk staggered can not loose, the whole piece of hook mesh can not loose deformation. Of course, if the customer special requirements out of the net, showing loose phenomenon can not blame the production side. Whether the mesh meets the specification requirements and the wire diameter meets the wire diameter.
3. Zinc layer structure: The structure of zinc layer includes grain size, grain shape and the combination of zinc layer and substrate, etc., which has a certain impact on corrosion resistance. In general, the finer the grain size, the denser the structure, and the better the corrosion resistance.
Post time: 20-10-22Greenhouse special electroplating process iron wire blackening solution:
- Galvanized wire coating is galvanized, aluminum plated, coated with nylon or plastic, etc. Zinc is divided into thin coating of steel wire after plating and thick coating of galvanized steel wire after drawing. The mechanical properties of thick coating are reduced compared with smooth steel wire rope, which should be used in severe corrosion environment. It is more resistant to corrosion, wear and heat than galvanized wire rope, using the first plating and then drawing method of production. Coated nylon or plastic wire rope is divided into two kinds of coated rope and coated stock after the rope.
The wire mesh is composed of low carbon steel wire or medium carbon steel wire, high carbon steel wire or stainless steel wire. There are two kinds of manufacturing technology of steel wire mesh, one is the weaving method, the other is the welding connection, the formation of grid.
- The most obvious gap in a short period of time is the cross section of this piece, hot dip galvanized wire because it is surface anti-corrosion treatment, so in the cross section of this piece will appear rust, and stainless steel wire because the internal raw materials and surface raw materials are consistent, so there is no such situation.
Post time: 04-01-23In reinforced concrete structure, the crack width of cold wire drawing is smaller than that of circular steel bar or even that of hot rolled thread bar. So cold wire drawing is more popular in the construction industry. The material for cold drawing is made of steel bars and can be simply explained how it is made, that is, its production process is simple. It’s based on steel bars, which are constantly stretched evenly, stretching the bars into something very thin, like wire drawing, without plasticity.
Stainless steel wire is characterized by good corrosion, in chemical plants or pharmaceutical industry can often be used to stainless steel wire, suitable for acid, alkali environment. Aluminum alloy wire is characterized by high temperature, can adhere to the high temperature of more than 100 degrees Celsius does not fade, and has good corrosion, patience is also very good. It can be used for device manufacturing in construction industry.
The price of galvanized iron wire performance is the key to win, galvanized wire only with good performance, in order to win the market, in order to obtain customer praise. In galvanized wire, the main function of carbon in increasing hardness, less is less easy to rust, the main function of chromium is acid and alkali resistance; Nickel’s main function is high temperature resistance, acid and alkali resistance and conductive use; The main function of iron is magnetic conductivity; The main functions of titanium are low density, high hardness and strong corrosion resistance. The main function of copper is magnetic and electrical conductivity. Different chemical components have different functions, which together form the characteristics of galvanized wire.
Electrode application range is wide, can realize a variety of materials, a variety of profiles and a variety of joint forms of welding. (1) Welding between low carbon steel, low alloy steel, medium carbon steel, alloy steel and other metal materials or dissimilar metal materials can be achieved. The weld has good comprehensive mechanical properties, and the tensile strength can reach more than 400MPa. ⑵ Can realize the welding of large plate, steel frame, plate – tube, rod – rod, tube – tube and other profiles. ⑶, can realize docking, Angle, lap, T joint and other joint forms of welding. ⑷ mainly suitable for flat welding.(5) it can surfacing the parts of wear failure, so as to obtain the surface surfacing layer with melting depth, smooth surface and excellent performance. ⑹ It can be realized that no bevel 1 ~ 6mm thick metal sheet single-side welding double-side molding.
Dip plastic six side barbed wire corrosion lost the original characteristics, in the shape, color and mechanical properties and other aspects will change, resulting in equipment damage, pipeline leakage, in particular, is prone to fracture, lose the original protective function.
- 5, there are no special requirements: such as whether to shrink packaging, etc.
- Most builders buy hot-dip galvanized wire. They want good corrosion resistance. And people use galvanized wire products in their daily life, such as wire mesh guardrail, galvanized wire is more, which still takes into account the cost. In addition, galvanized silk will also be used in the field of art. Artists are attracted to its bright color and softness, so the factory must consider these factors when producing galvanized silk.
The characteristics of this kind of small animal cage, is small, light, easy to carry, but also easy to clean care. For small animal cages, the wire diameter of the general iron wire is not very large, the thickness of the plastic is relatively thin, so the use of the time can not be “violent”, or the cage under the “destruction” will occur welding or plastic crack off.
Post time: 21-02-23Moderate rates of foam formation may be harmless. The small homogeneous particles with large denier in the tank can stabilize the foam layer, but the accumulation of too many solid particles will cause explosion. Using activated carbon mat to remove the surface active substances, or through the filtration of foam is not very stable, this is an effective measure; Other measures should also be taken to minimize the introduction of surfactant.
Hot plating wire can generate thicker coating, and there are both pure zinc layer and iron zinc alloy layer, so the corrosion resistance is better. The production power of hot dip galvanizing is particularly high, and the duration of the parts in the hot dip galvanizing tank usually does not exceed lmin. Compared with galvanizing, hot-dip galvanizing has lower production cost and less environmental impact than galvanizing. To plate, tape, wire, tube and other profiles plating, automation degree is higher.
Now the production of stainless steel blade barbed rope unless it is a specially customized model, under normal circumstances are the use of a knife length of 22mm mold production, that is, we usually say bto-22 type. It’s not necessarily the case that there are specifications from 11mm to 65mm. Unless the customer insists on customizing the required length, the barbed rope manufacturer produces bto-22 stainless steel blade barbed rope.
The methods to control the thickness of galvanizing are as follows: you can slow down the lifting speed of the workpiece, control the time of galvanizing as far as possible, add the appropriate amount of thinning alloy, reduce the thickness, and improve the temperature of hot-dip galvanizing. But consider the zinc pot, iron pot should not exceed 480 degrees, ceramic pot can be 530 degrees, which can reduce the time of zinc immersion.
- Hexagonal cage has a wide range of applications, with the progress of science and technology, has been extended to the major hydraulic engineering, civil engineering. Geotechnical engineering and other projects. In the hydraulic hexagonal cage in the river construction to reach the utility, that is appropriate and the use of hexagonal cage used to fill stone, fixed river, can avoid river erosion bring water and soil loss. In the civil engineering project, the hexagonal cage is considered appropriate and the use of similar particle size volume particle filling, cage between the formation of a mesh wall, which is the stone cage mesh retaining wall.
- In addition, galvanized can also improve the beauty and decoration of the product. The surface of galvanized products has a silver-white luster, with better silver light reflection performance, in some cases that need to be decorated beautifully, galvanized products are usually more attractive than non-galvanized products. In addition, due to the existence of galvanized film, the surface of the product is not easy to be eroded by external oxygen, water and other substances, and can maintain the finish and beauty for a longer time.
Therefore, the rust of galvanized black iron wire has a great relationship with storage. At the same time, after rust, it should also be reasonable for post-treatment to avoid affecting its use effect. Of course, when the black iron wire is galvanized, the thickness of the galvanized layer should be ensured, so that the possibility of rust can be reduced. Speaking of galvanized iron wire, perhaps many people think it is relatively rare, in fact, it is not.
Generally, due to wet weather and more precipitation, oxidation and rust of binding iron wire NetEase occurs, so we should better store and use galvanized iron wire to avoid rust as far as possible. About the barbed wire, the surface of the barbed wire attached a layer of galvanized layer, the galvanized layer if too thick will not meet the SGS environmental standards. But if it is too thin, it is easy to oxidize with water molecules and rust.
Most of the production enterprises or large public places, they can play a defense hook mesh in the choice of time, often will hook mesh quality in position, so galvanized hook mesh this product few people are interested in, but does this show that galvanized hook mesh is not useful?
Post time: 14-02-23- Galvanized wire for welding is generally required to have a certain hardness, after acceptance of galvanized wire, feel is the first thing to do, in addition to the machine test, because the average user does not have testing equipment, on the machine trial is also a very inconvenient way to test. The diameter of electric galvanized wire is measured with a micrometer, and it is kept at about 0.02mm above and below the contract signing standard, with neat appearance, no leakage plating and no messy wire.