- Preparation process: single twist plait, double twist plait.
- 1, first of all, the net surface is smooth, mesh are four lines, pitch is the same, whether the weft wire bending (note: the net width is the length of the weft wire), normal weft wire passes through the straight wire of welded wire mesh, with accurate time and the silk repeated welding, make the pitch of welded wire mesh is consistent, with smooth surface, into a square hole, when the net vertical position from the top downwards see, weft wire is straight.
With the increasing use of hook mesh, the method of bridge rail is also different. The height of the outer railing of the walkway or seat belt should not be lower than 1.10 meters. The net distance between railings should not be greater than 140 mm and horizontal bar rails should not be used. The planning of the hook mesh is necessary to be safe and reliable, the bolt should be installed on the basis of the railing, its strength should meet the requirements of the standard.
- If adult dogs and puppies touch noses out of love for the dog, then adult dog nose touch is more meaningful. For example, dogs can touch their noses to communicate where food is safe and whether people or other animals are in danger.
- The surface coating of galvanized wire can be seen whether the quality of galvanized wire is good or not. If the strength of zinc attached to the wire is very poor, then this galvanized wire do not buy, because this galvanized wire must be poor galvanized wire. High quality galvanized wire in general, the zinc layer attached to the surface of the wire is relatively thick, so when we buy galvanized wire, as long as we look at the thickness of the zinc layer, we can generally judge the quality of galvanized wire.
Uses: water conservancy engineering, river regulation engineering, dike engineering, ecological protection engineering, channel lining, road engineering, river bank reinforcement, ocean engineering, landscape design engineering, bridge reinforcement, railway and highway slope protection, retaining wall, ecological river bank slope regulation and other engineering.
Generally speaking, in dry main gas and indoor use, the thickness of galvanized coating is only 6-12μm, but under poor environmental conditions, the thickness of galvanized coating is 20μm, can reach 50μm. Therefore, environmental factors should be considered when choosing the thickness of galvanized layer. Galvanized layer after passivation treatment, can naturally form a layer of bright, beautiful color passivation film, can obviously improve its protective function, decorative.
Post time: 10-11-22- D, coating adhesion; The zinc layer of the plating parts should be firmly combined with the base metal with sufficient adhesion strength, and will not fall off or bulge after the hammer test.
- Hook mesh from the point of view of weaving quality inspection requirements, hook mesh wire and silk staggered can not loose, the whole piece of hook mesh can not loose deformation. Of course, if the customer special requirements out of the net, showing loose phenomenon can not blame the production side. Whether the mesh meets the specification requirements and the wire diameter meets the wire diameter.
1. Choose the right cage for your dog according to its size
- Using the patented technology of the invention, regularly put zinc block into the plating aid pool, so that the bivalent iron in the plating aid into trivalent iron, and play a stable PH value in a numerical range of an important measure, but also easy to filter out the trivalent iron ions in the plating aid; Ferric ion is controlled between 0.3 and 1.0g/L; When hydrogen is not released in the plating aid, the zinc block is continued. It is an effective measure to reduce zinc slag, improve the fluidity of zinc liquid and reduce the thickness of zinc layer to play the role of plating aid filter.
1, no paint and maintenance, long new not old, exempt you from maintenance fatigue and trouble, the lowest comprehensive cost. Stainless steel wire mesh can be used as poultry cage, egg basket, channel fence, drain tank, porch guardrail, anti rat net, mechanical protective cover, livestock and plant fence, grid frame, etc.
Post time: 02-02-23- Hongyu twist flower hexagonal mesh factory is the selection of low carbon steel silk woven, mesh structure he has the characteristics of corrosion resistance, high strength and ductility. Steel wire diameter up to 2.0mm-4.0mm, steel wire appearance is usually selected hot dip galvanized maintenance, galvanized maintenance layer thickness can be made according to customer needs, galvanized maximum can reach 300g/㎡.
- The acid activation solution in the production process can remove the corrosion products and oxide film on the surface of the low carbon steel wire without excessive corrosion to the matrix. Galvanized wire can be zincate galvanized or chloride galvanized process, should use appropriate additives to obtain the low carbon steel wire standard requirements of the coating. When galvanized wire after light plating should be light treatment. Control the temperature of the bath of galvanized wire.
- 4, barbed rope fence and culvert intersection, such as the ditch is narrow, barbed rope barbed rope fence can be directly across the ditch is wider, barbed rope barbed rope fence is difficult to cross, can take bridge, channel processing method.
- Take the blade cord for example, the quality of the cord and the shape and direction of the surface barbs are what consumers need to consider.
Hot dip galvanized hexagonal net is made of low carbon steel wire by mechanized braided welding and then by hot dip zinc treatment. The net color is white and shiny, thick zinc layer, uniform mesh, flat mesh surface, solder joint tension resistance, high corrosion resistance. The surface of the steel wire is usually protected by hot-dip galvanizing, and the thickness of the galvanized protective layer can be made according to the requirements of customers. Hot-dip galvanizing hexagonal net is another kind of twisting mesh corresponding to the galvanizing hexagonal net.
Post time: 20-04-23Strength of galvanized wire: tensile strength is the great tensile stress that the material can withstand before tensile fracture; Yield strength has two indexes: upper yield and lower yield. It is a process in which the stress does not increase but the deformation continues to occur during the tensile process. When the force value drops for the first time, the major stress is the yield strength, and the yield strength must be less than the tensile strength.
If the zinc coating is good, but when the light comes out in 3% nitric acid, there is a dark shadow on the coating, and the film is brown when passivation occurs, which may be caused by foreign metal impurities such as copper or lead in the galvanized liquid. When there is a problem in the process of galvanizing, check the temperature and current density first, and then measure and adjust the content of zinc and sodium hydroxide in the bath through the analysis of the bath. Whether DPE levels are low can be determined by Hull cell test.
- The design is not only for ease of installation, but also for harsh terrain conditions such as cliffs, with little anchorage and little excavation to achieve a quick and easy installation. Based on the characteristics of heavy hexagonal net twisted-pair structure, it can withstand the impact of falling rock even in the case of wire breakage.
- The principle of hot dip galvanizing is simply that clean iron parts are immersed in a zinc bath through Flux wetting, so that the steel reacts with molten zinc to produce an alloyed skin film.
Post time: 14-12-22